Vision Operator’s Manual (v12.0 MD) Switcher Basics • Ops 4–33
Defaulting Color Correctors
You can default each color corrector element as you are adjusting them, or you can default all the
inputs or buses that you have applied color correction to.
Use the following procedure to default all Proc Amp and RGB color correction settings:
1. Double-press the crosspoint button for the video source, or bus, that you want to default.
The current selection is displayed in the upper left corner of the menu.
2. Press More.
Video Correction Menu 2-2
3. Default the current Input and Buses as follows:
• Press Default Bus & Input on the Video Correction Menu 2-2. A confirmation
message is displayed prompting you to either confirm or cancel the defaulting
procedure.
4. Default all the Inputs as follows:
• Press Default All Inputs on the Video Correction Menu 2-2. A confirmation
message is displayed prompting you to either confirm or cancel the defaulting
procedure.
5. Press Confirm to accept the changes. If you press Cancel, none of the color correctors
are defaulted.
This completes the procedure for defaulting all Proc Amp and RGB color correction settings.
Copying and Pasting Color Correctors
Once you have applied Proc Amp and RGB Color Corrector adjustments to a specific input or
video bus, you can copy these settings to other inputs or buses.
Use the following procedure to copy Proc Amp and RGB color correction settings:
1. Double-press the crosspoint button for the video source, or bus, that you want to copy.
The current selection is displayed in the upper left corner of the menu.
2. Press More.
To Next Page
Loading...
