Ops 4–34 • Switcher Basics Vision Operator’s Manual (v12.0 MD)
Video Correction Menu 2-2
3. Copy an Input Color Corrector as follows:
• Press Copy Input on the Video Correction Menu 2-2 to copy the input-based
Proc Amp and RGB color corrector settings for the selected input.
• Press a crosspoint button to select the video source that you want to copy the color
corrector settings to. The current selection is displayed in the upper left corner of
the menu.
• Press Paste Input on the Video Correction Menu 2-2 to paste the color corrector
settings to the destination input. A new color corrector is assigned to the input if one
was not already assigned.
4. Copy a Bus Color Corrector as follows:
• Press Copy Bus on the Video Correction Menu 2-2 to copy the bus-based Proc
Amp and RGB color correctors settings for the selected bus. A brief message
appears confirming the copy.
• Press a crosspoint button to select the bus that you want to copy the color corrector
settings to. The current selection is displayed in the upper left corner of the menu.
• Press Paste Bus on the Video Correction Menu 2-2 to paste the color corrector
settings to the destination bus. A new color corrector is assigned to the bus if one
was not already assigned.
This completes the procedure for copying Proc Amp and RGB color correction settings.
To Next Page
Loading...
