Vision Operator’s Manual (v12.0 MD) Switcher Basics • Ops 4–41
Copy and Swap Buses
The menus can be used to copy or swap the contents of a bus to another. The contents of one
source bus can be copied to multiple destination buses. A swap can only be performed between
two buses.
Use the following procedure to copy or swap the contents of a bus to another:
1. Navigate to the Copy Buses Menu as follows:
• Press HOME B Attributes B Copy Buses.
Copy Buses Menu
2. Select a copy or swap as follows:
• Press Copy on the Copy Buses Menu to select a copy.
• Press Swap on the Copy Buses Menu to select a swap.
3. In the Source area, select the MLE and Buses that you want to copy or swap from. If
you select more than one source bus, the destination buses are fixed to the same buses
for the selected destination MLE.
4. In the Destination area, select the MLE and Buses that you want to copy or swap to.
Note — You cannot have the same bus selected for the Destination and Source to perform a
Copy or Swap.
5. Press Perform on the Copy Buses Menu to perform the copy or swap.
This completes the procedure for copying or swapping the contents of a bus to another.
To Next Page
Loading...
