Vision Operator’s Manual (v12.0 MD) Transitions • Ops 5–11
Setting the Rate From the Global Memory Module
The Keyer, Effects, and MLE rates for an MLE can also be set from the Global Memory
Module. This allows you to set the MLE 1 rates on the Vision 2 switcher, which does not have an
Effects Memory Module.
Use the following procedure to set the transition rates for an MLE from the Global Memory
Module:
1. Press and hold the KEY RATE, EFF RATE, or MLE RATE button on the Global
Memory Module. The MLE button on the Recall area indicates which MLE you are
currently setting the rate for.
2. Press the MLE X button in the Store or Recall area of the Global Memory Module to
set the rate for that MLE, where X represents the MLE number. You cannot use the ALL
button to set the rate across multiple MLEs at the same time.
3. Use the keypad in the center of the module to enter the new duration, in frames. The new
rate appears on the top line of the display as you enter it.
4. Press ENTER on the Global Memory Module to accept the new rate.
This completes the procedure for setting the transition rates for an MLE from the Global Memory
Module.
To Next Page
Loading...
