Ops 10–6 • Peripheral Control Vision Operator’s Manual (v12.0 MD)
Audio Server Clip Control
Audio Server Clips can be cued and played by selecting the Clip Register, or Clip ID, on the
Audio Server Menu, or by using the keypad on the Global Memory Module.
For More Information...
• on using the ROLL CLIP to play a cued clip, refer to the section “ROLL CLIP” on
page Ops 5-5.
Cueing a Cut Using the Keypad
Clips can be recalled from the keypad on the Global Memory Module using the Clip Number.
The keypad will automatically be assigned to clip recall when a BNC that is assigned to an Audio
Server is selected.
Use the following procedure to cue a clip using the keypad:
1. Press Recall Clip on the Global Memory Module to show the Audio Server Clip ID or
Clip Number on the display.
2. Enter the Clip Number, using the keypad on the Global Memory Module.
3. Press Enter to cue the Clip.
This completes the procedure for cueing a clip using the keypad.
Audio Server Menu
The Audio Server Menu allows you to select and play a clip/cut from the Audio Server.
Use the following procedure to select and play an audio clip:
1. Navigate to the VTR Clips Menu as follows:
• Press HOME B More B Clips B Browse Audio Clips.
2. Press Device on the Audio Server Menu.
3. Use the Device knob on the Audio Server Menu to select the audio server that you
want to cue and play a clip on.
4. Press Cut ID on the Audio Server Menu.
Cut ID (DigiCart) — Audio Server Clip Menu
To Next Page
Loading...
