Vision Operator’s Manual (v12.0 MD) Peripheral Control • Ops 10–7
Note — The Cut ID Menu is device specific, and may vary depending on the audio server you
are selecting the clip on.
5. Select the clip/cut you want to play as follows:
•Use the Drive knob on the Audio Server Menu to select the drive on the audio
server that the clip is stored on.
•Use the Directory knob on the Audio Server Menu to select the directory on the
audio server that the clip is stored on.
•Use the Cut knob on the Audio Server Menu to select the clip.
6. Use the transport controls to Play, Pause, or Stop the clip.
This completes the procedure for selecting and playing an audio clip.
To Next Page
Loading...
