Ops 4–32 • Switcher Basics Vision Operator’s Manual (v12.0 MD)
Aux Bus Color Correction
The Vision switcher has a set number of color correctors that can be assigned to Aux Buses, based
on the number of MLEs that your switcher has. For example, if you have 4 MLEs, you will have
4 color correctors available to your Aux Buses.
Aux Bus color correction works similar to Bus-based color correction. Color Correction settings
are applied to the output of the Aux Bus, and not to the selected video sources on the bus. If the
Aux Bus is set up as an AuxKey, the color correction will include the keys.
Assigning Aux Bus Color Correctors
Use the following procedure to assign a color corrector to a specific Aux Bus:
1. Double-press a crosspoint button on the Aux Bus that you want to assign the color
corrector to. Refer to the section “Selecting an Aux Bus” on page Ops 4-8 for more
information in selecting an Aux Bus. The Video Correction Menus is displayed.
2. Press Assign Corrector on the Video Correction Menu 1-2 to assign an available
color corrector to the current Aux Bus.
Video Correction Menu 1-2
Note — If all the available color correctors have already been assigned, the Assign Corrector
button appears gray. You must free up one of the color correctors assigned to another Aux Bus
to assign it to the selected one. The list on the left side of the menu displays where all the color
correctors are assigned to Aux Buses. Refer to the section “Removing Aux Bus Color
Correctors” on page Ops 4-32 for more information.
3. Press Bus Proc Amp or Bus RGB to set up the color corrector for the Aux Bus.
This completes the procedure for assigning a color corrector to a specific Aux Bus.
Removing Aux Bus Color Correctors
Use the following procedure to remove a color corrector from a specific Aux Bus:
1. Double-press a crosspoint button on the Aux Bus that you want to remove the color
corrector from. Refer to the section “Selecting an Aux Bus” on page Ops 4-8 for more
information in selecting an Aux Bus. The Video Correction Menus is displayed.
2. Press Remove Corrector on the Video Correction Menu 1-2 to remove the color
corrector from the current Aux Bus.
This completes the procedure for removing a color corrector from a specific Aux Bus.
To Next Page
Loading...
