Ops 4–8 • Switcher Basics Vision Operator’s Manual (v12.0 MD)
• on assigning a bus map, refer to the section “Assigning Panel Bus Maps” on page Eng
7-19.
• on setting up default MLE maps, refer to the section “Default MLE Map Assignment”
on page Eng 12-4.
• on selecting sources for a transition, refer to the section “Performing Transitions” on
page Ops 5-12.
• on Frontside/Backside video, refer to the section “Frontside/Backside Video” on
page Ops 12-14.
Selecting a Key or Utility Bus
The SEL button cycles through all the keyers and utility buses available on the Panel Row, unless
the Lock Bus feature is on. The utility buses that are available depends on what the Key 4 Flexi
Mode is set to.
Use the following procedure to assign the Key Bus on a Panel Row to a particular Keyer or
Utility Bus using the MLE SEL Button Menu:
1. Press the SEL button on the Panel Row that you want to set the Key Bus assignment on.
The MLE SEL Button Menu for the selected Panel Row is displayed.
2. Press Select Key/Util Bus on the MLE SEL Button Menu.
Key and Utility Bus Selection — MLE SEL Button Menu
3. Press the Key X or Util X button on the MLE SEL Button Menu to select the Keyer or
Utility Bus that you want to assign to the Key Bus, where X is the number of the key or
utility bus. If the MultiDSK option is installed, the 2 additional keyers, Key 3 and
Key 4, are shown next to the existing Keyers.
This completes the procedure for assigning the Key Bus on a Panel Row to a particular Keyer or
Utility Bus.
For More Information...
• on the Key 4 Flexi Mode, refer to the section “Selecting a Key 4 Flexi Mode” on
page Ops 4-9.
Selecting an Aux Bus
From the MLE SEL Button Menu you can assign the Key Bus of the Panel Row to an Aux Bus
or the entire Panel Row to an AuxKey. When you select an Aux for a Panel Row, the Key Bus of
the Panel Row changes to the Aux glow color and the mnemonics for the Panel Row show the
sources for the Aux Bus.
Use the following procedure to assign the Key Bus to an Aux Bus:
To Next Page
Loading...
