Vision Operator’s Manual (v12.0 MD) Switcher Basics • Ops 4–9
1. Press the SEL button on a Panel Row that you want to assign to an Aux Bus. The MLE
SEL Button Menu is displayed.
2. Press Select Aux Bus on the MLE SEL Button Menu.
Aux Bus Selection — MLE SEL Button Menu
3. Press the Bank X button on the MLE SEL Button Menu to select the Aux Bus Bank
that you want to use, where X is the number of the bank.
4. Press the Aux X or AuxKey X button on the MLE SEL Button Menu to select the
Aux Bus that you want to use, where X is the number of the aux bus.
5. Toggle the Locked button on the MLE Sel Button Menu to lock or unlock the selected
Aux Bus. When locked, you cannot change the source selected on the bus, and the Bus
Hold crosspoint button is lit.
Operating Tip — You can also use the Aux Bus Outputs Menu 1-2 (HOME B More
B Aux Bus) to assign the Key Bus to an Aux.
This completes the procedure for assigning the Key Bus to an Aux Bus. Selections made on the
Key Bus will now be applied to the selected Aux. You can quickly assign the Key Bus back to the
Keyer by pressing the SEL button.
Selecting a Key 4 Flexi Mode
From the MLE SEL Button Menu you can assign the Key 4 Flexi Mode for the selected MLE.
This selects the sources and functions available to Keyer 4 when it is in Flexi Mode. Key 4 must
be set to Flexi Mode to be able to set Key 4 to Internal or External.
This option is only available on the QMD/X frames.
Use the following procedure to assign the Flexi Mode to Key 4:
1. Press the SEL button on the Panel Row that is assigned to MLE 1. The MLE SEL
Button Menu is displayed.
2. Press Key 4 Flexi Mode on the MLE SEL Button Menu.
To Next Page
Loading...
