Ops 4–10 • Switcher Basics Vision Operator’s Manual (v12.0 MD)
Key 4 Flexi Mode Selection — MLE SEL Button Menu
3. Set Key 4 to External or Internal mode as follows:
• Press the Key 4 External button on the MLE SEL Button Menu to assign Key 4
to External Mode. In this mode Key 4 can access all sources and two Clean Feeds
are available. Utility Buses or Aux Bus color correctors are unavailable.
• Press the Key 4 Internal button on the MLE SEL Button Menu to assign Key 4
to Internal Mode. Key 4 can only access MLE-Stores and the selected MLE has two
Utility Buses and two Clean Feeds available. No Aux Bus color correctors are
available.
This completes the procedure for assigning the Flexi Mode for Key 4.
For More Information...
• on setting the Key 4 Mode, refer to the section “Key 4 Mode” on page Eng 12-7.
Selecting an MLE
From the MLE SEL Button Menu you can assign the Panel Row to an MLE. The number of
MLEs you have to assign depends on the MLE options you have purchased, and the hardware you
have installed. Assigning Panel Rows to different MLEs does not change the default MLE Map.
Keep the following in mind when assigning MLEs to Panel Rows:
• If you assign a Panel Row to a different MLE, the accompanying Transition, Keyers, and
Memory Modules are also assigned to that MLE.
• If you assign the Program/Preset MLE to a Panel Row that does not have the
Downstream Keyer Module associated with it, the MultiDSK keys will not be available.
• If you assign an MLE to an External Panel Row that has an Auxiliary Control Panel on it,
the Auxiliary Control Panel will remain assigned to the select Aux Bus. MLE
assignments do not apply to Auxiliary Control Panels.
• If an MLE is not assigned to your control panel, you cannot select it.
Use the following procedure to assign the Panel Row to an MLE:
1. Press the SEL button on the Panel Row that you want to assign the MLE to. The MLE
SEL Button Menu for the selected Panel Row is displayed.
2. Press Assign MLE on the MLE SEL Button Menu.
To Next Page
Loading...
