Vision Operator’s Manual (v12.0 MD) Switcher Basics • Ops 4–11
MLE Assignment — MLE SEL Button Menu (8-MLE Shown)
Note — You cannot assign a Panel Row to an MLE that is currently re-entered onto the Panel
Row unless the Re-entry Loops Personality Option is turned on.
3. Select the Internal panel row (Row 1-8) or External panel row (Extern Row 1-16)
on the MLE Sel Button Menu that you want to assign an MLE to.
4. Press the MLE X button on the MLE SEL Button Menu to select the MLE that you
want to assign to the Panel Row.
This completes the procedure for assigning the Panel Row to an MLE.
Assigning a Quick Preset
To save a Panel Row assignment to one of the Quick Presets, you must first have the Panel Row
set up as you want it. Once set up, you can save the current bus assignment to a Quick Preset.
You cannot assign an MLE to a Quick Preset. Only Aux Buss, Keyers, Utility and AuxKeys can
be assigned to a Quick Preset.
Use the following procedure to store a bus assignment to a Quick Preset button:
1. Press the SEL button on the Panel Row that you want to assign the bus to. The MLE
SEL Button Menu for the selected Panel Row is displayed.
2. Set up the Panel Row as you want to store it.
3. Press Assign as Preset on the MLE SEL Button Menu.
Preset Selection — MLE SEL Button Menu
4. Press the preset button on the MLE SEL Button Menu to store the current Panel Row
setup to that Quick Preset.
This completes the procedure for storing a bus assignment to a Quick Preset button.
To Next Page
Loading...
