Ops 9–8 • Still-Store Vision Operator’s Manual (v12.0 MD)
Adjusting On-Air Properties
The on-air properties for a still allow you to adjust the position, display mode, and animation
attributes of stills and animations.
The on-air properties for Global-Stores are applied to the image or animation directly, regardless
of the channels that the image or animation are loaded in. If you adjust the on-air properties, or
animation properties, of the still in one channel, these settings are applied to that image or
animation in all other channels that the same image or animation is loaded into.
The on-air properties for MLE-Stores are applied to the current image, or animation, that is
loaded into the channel. This allows you to load the same image into multiple channels and adjust
the on-air properties independent of the other channels. All on-air properties adjustments for a
channel are lost when a new image is loaded into that channel.
Use the following procedure to adjust the on-air properties of a still:
1. Navigate to the Still-Store Menu as follows:
• Press HOME B Effects B Still Store.
2. Load the still you want to set the on-air properties for into a Global-Store or MLE-Store
channel. On-air property settings are applied to the still, and not the still-store channel.
3. Press On-Air Properties on the Still-Store Menu 1-2.
Still-Store Properties Menu
4. Adjust the position of the still-store image as follows:
• Press Position on the Still-Store Properties Menu.
• Use the knobs or positioner to adjust the position of the still-store image.
Note — You cannot position any portion of an image off-screen, as this may cause video
errors. Full screen images cannot have their position adjusted.
5. Adjust the still properties as follows:
• Press Still Properties on the Still-Store Properties Menu.
To Next Page
Loading...
