Ops 17–20 • WARP Effects Vision Operator’s Manual (v12.0 MD)
Obscure WARP
The Obscure WARP creates a pixelation effect bound in an oval or rectangle that can be
positioned over part of the key video.
Use the following procedure to set up an Obscure WARP:
1. Select and activate the Obscure WARP effect on the keyer you want to apply it.
2. Press Pixelation on the S&T WARP Menu.
Obscure (Pixelation) — S&T WARP Menu
3. Adjust the pixelation of the effect as follows:
•Use the (X) knob on the S&T WARP Menu, or the positioner, to adjust the size of
the pixels horizontally.
•Use the (Y) knob on the S&T WARP Menu, or the positioner, to adjust the size of
the pixels vertically.
•Use the Overall knob on the S&T WARP Menu, or the positioner, to adjust the
size of the pixels both horizontally and vertically at the same time.
4. Adjust the position of the obscure as follows:
• Press Position on the S&T WARP Menu.
Obscure (Position) — S&T WARP Menu
•Use the Center (X) knob on the S&T WARP Menu, or the positioner, to
horizontally adjust the position of the obscure over the key video.
•Use the Center (Y) knob on the S&T WARP Menu, or the positioner, to vertically
adjust the position of the obscure over the key video.
•Use the Size knob on the S&T WARP Menu, or the positioner, to adjust the size of
the obscure over the key video.
To Next Page
Loading...
