Vision Operator’s Manual (v12.0 MD) WARP Effects • Ops 17–19
5. Adjust the slope and phase of the trailing edge of the effect as follows:
• Press Curve on the S&T WARP Menu.
Melt (Curve) — S&T WARP Menu
•Use the Slope knob on the S&T WARP Menu, or the positioner, to adjust the
angle of the melt.
•Use the Phase knob on the S&T WARP Menu, or the positioner, to adjust the
position of the waves across the trailing edge of the melt.
This completes the procedure for setting up a Melt WARP.
To Next Page
Loading...
