Vision Operator’s Manual (v12.0 MD) Peripheral Control • Ops 10–5
2. Press VTR Control on the Remote Control Select Menu.
3. Use the BNC knob on the Remote Control Select Menu to select the VTR you want to
cue a clip for.
4. Press GO!! on the Remote Control Select Menu.
Note — If the switcher does not receive a response from the VTR in over 2 seconds, the
switcher will report the communications with the VTR has been lost. Double check the cable
connections and that the VTR is operational.
VTR Remote Control — Remote Control Menu 1-2
Operating Tip — The Remote Control Menu identifies the specific VTR you are controlling
by the BNC that it is connected to, and the communications protocol that is being used to control
the VTR.
5. Use the Clip knob on the Remote Control Menu 1-2 to select the Clip Register you
want to cue. You can play or preview the clip manually using the transport controls on
the menu.
Operating Tip — You can adjust the speed at which a clip is played by pressing Play Speed
on the Remote Control Menu 1-2, and using the Speed knob to adjust the speed for the clip.
6. Press Cue Clip on the Remote Control Menu 1-2 to cue the selected clip. The clip is
now ready to be played using the ROLL CLIP button.
This completes the procedure for cueing a clip using the Remote Control Menu.
To Next Page
Loading...
