Vision Operator’s Manual (v12.0 MD) Squeeze & Tease Sequences and Wipes • Ops 15–15
Running Multiple Sequences
You can run multiple sequences at once just as you would run a single sequence.
Use the following procedure to run multiple sequences:
1. Set up a sequence in each keyer that you want to run a sequence on.
2. Select the Keyers as the next transition on the Transition Module of the MLE.
3. Press the SEQ button on the Transition Module to display the S&T MD Runtime
Menu.
S&T MD Runtime Menu
Operating Tip — You can run or pause an individual sequence by toggling Key X on the
S&T MD Runtime Menu to Run or Pause, where “X” is the number of the key.
4. Run the sequences using the fader, or by pressing the AUTO TRANS or CUT button on
the Transition Module.
This completes the procedure for running multiple sequences.
For More Information...
• on setting up and perform a transition, refer to the section “Performing Transitions” on
page Ops 5-12.
• on the pre-loaded patterns, refer to the section “Squeeze & Tease MD Wipes and
Sequences” on page Ops 18-2.
• on creating or modifying a sequence, refer to the section “Creating a Sequence” on
page Ops 15-3.
• on the default sequence rate, refer to the section “Personality List” on page Eng 11-2.
To Next Page
Loading...
