Ops 10–18 • Peripheral Control Vision Operator’s Manual (v12.0 MD)
› List — List view shows you a list of all the pages, or events, that are available. In
this view you can load an event to either the PV or PGM of the character generator
using the List to PV or List to PGM buttons.
› Current — Current view shows you the pages, or events, that are currently listed on
the PV and PGM of the character generator.
• List to PGM — This command allows you to load a page, or event, for the Program
channel of the character generator. The selected page will be added to the Program list.
This command is only available in List view.
• List to PV — This command allows you to load a page, or event, for the Preview
channel of the character generator. The selected page will be added to the Preview list.
This command is only available in List view.
• Play Animation — This command allows you to play a template animation.
• Recall CG to PGM — This command allows you to recall a page, or event, to the PGM
Channel of the character generator using the keypad on the Global Memory Module.
The tag information for the file is displayed in the PGM column on the menu.
• Recall CG to PV — This command allows you to recall a page, or event, to the PV
Channel of the character generator using the keypad on the Global Memory Module.
The tag information for the file is displayed in the PV column on the menu.
• Run Effect — This command takes the current page, or event, from the PV column to
the PGM column using the selected effects. The next page, or event, will automatically
be shown in the PV column.
• Select Directory — This command allows you to change the current directory, or
folder, that you are using to load templates from. Enter the name of the folder in the
Folder field.
• Select Effect — This command takes you to the CG – Select Effect Menu, which
allows you to apply different effects to the transitions on the character generator. These
effects are applied when you take the next
page, or event, in the PV column to the PGM
using the Run Effect command.
• Select File — This command allows you to load a sequence file on the character
generator. Enter the name of the file in the Folder/FileName field. This command is only
available in Sequence mode. The available effects will depend on the character generator
you are controlling.
• Sequence/Manual Mode — This commands allows you to toggle between Sequence
(Seq.) and Manual (Man.) mode. The commands available on the menu depend on the
mode you are operating in.
› Sequence — In Sequence mode, the pages, or events, are all loaded up and play
out automatically.
› Manual — In Manual mode, you load each page, or event, individually, and take it
to air manually.
• Swap PV <–> PGM — This command allows you to swap the templates loaded on the
PGM with those loaded on the PV.
Notes on Character Generator Commands
• The current Mode, Channel, and Folder/FileName information is saved in non-volatile
memory on the switcher and is stored and recalled with the Personality settings. This
allows you to retain your character generator settings if the switcher powers down.
• Templates stored with non-numerical names cannot be recalled using the keypad on the
Global Memory Module.
• Character generator parameters that are modified from the switcher are only in effect for
the current session.
To Next Page
Loading...
