Vision Operator’s Manual (v12.0 MD) WARP Effects • Ops 17–27
5. Adjust the lighting of the effect as follows:
• Press Lighting on the S&T WARP Menu.
Ripples (Lighting) — S&T WARP Menu
•Use the Intensity knob on the S&T WARP Menu, or the positioner, to adjust the
intensity of the lighting on the waves of the effect.
6. Apply movement to the effect as follows:
• Press Movement on the S&T WARP Menu.
Ripple (Movement) — S&T WARP Menu
•Use the Continuous knob on the S&T WARP Menu, or the positioner, to adjust
the amount of motion there is in the waves moving away from the center. At 0.0%
there is no movement.
•Use the Waterdrop knob on the S&T WARP Menu, or the positioner, to adjust
the intensity of the waterdrop effect at the center of the ripple effect.
This completes the procedure for setting up a Ripple WARP.
To Next Page
Loading...
