Ross Vision - Page 38

Ops 2–12 • Control Panel Introduction Vision Operator’s Manual (v12.0 MD)
• Individual MLEs (1-4) — To reset MLEs 1-4 individually, press and hold both the MLE
# button in the Recall and the MLE # button in the Store areas (Figure 2.10). Where the
# is the number of the MLE you want to reset. For example, to reset MLE 1, you would
press and hold the MLE 1 buttons. You can only reset MLEs that are assigned to your
control panel.
• Individual MLEs (5-8) — To reset MLEs 5-8 individually, toggle +4 on and press and
hold both the MLE # button in the Recall and the MLE # button in the Store areas
(Figure 2.10). Where the # is the number of the MLE you want to reset. For example, to
reset MLE 5, you would toggle +4 on, and press and hold the MLE 1 buttons. You can
only reset MLEs that are assigned to your control panel.
Note — You cannot reset an individual MLE from the 1-4 MLE and the 5-8 MLE at the same
time.
Figure 2.10 Press to Reset an Individual MLE
This completes the method for resetting an individual MLE, or all MLEs, from the Global
Memory System Module.
Resetting from an Individual MLE
From each individual Effects Memory Module you can reset the MLE individually.
Use the following method to reset an MLE from the Effects Memory Module:
• Press and hold both the Recall and Store buttons in the Effects Memory Module
(Figure 2.11).
Figure 2.11 Press to Reset an individual MLE
789
456
123
+/-
0
.
BANK CLEAR ENTER
MLE
2
MLE
1
ALL
+4
MLE
4
MLE
3
MLE
2
MLE
1
RECALL
CLIP
ALL
MLE
4
MLE
3
FADE
RATE
MLE
RATE
EFF
RATE
KEY
RATE
UNDO
ATTRIB
KEYS
ONLY
EFF
DISS
G LOBAL M EMORY
MLE 1 Reset
MLE 5 Reset (+4)
MLE 2 Reset
MLE 6 Reset (+4)
MLE 3 Reset
MLE 7 Reset (+4)
MLE 4 Reset
MLE 8 Rest (+4)
MLE 1 Reset
MLE 5 Reset (+4)
MLE 2 Reset
MLE 6 Reset (+4)
MLE 3 Reset
MLE 7 Reset (+4)
MLE 4 Reset
MLE 8 Rest (+4)
RECALL
789
456
123
BANK
0
ENTER
KEYS
ONLY
EFF
DISS
STORE
MLE
RATE
KEY
RATE
E FFECTS M EMORY
Reset MLEReset MLE
EFF
RATE
ATTRIB