Ross Vision - Page 113

Vision Operator’s Manual (v12.0 MD) Transitions • Ops 5–15
Operating Tip — Double-press the BKGD button to select background and all of the on-air
keys. The Double-Press BKGD personality option must be set to Trans Clean.
Figure 5.23 Background Transition — Transition Module (4-Keyer Shown)
4. Select the transition type that you want for this transition. In this example, a Dissolve
(DISS) has been selected (Figure 5.23).
5. If you want to select a different MLE rate or Key rate, set it now. Refer to the section
“Transition Rates” on page Ops 5-9 for more information on setting transition rates.
6. Press AUTO TRANS on the Transition Module to perform the transition. The progress
bar to the left of the fader handle shows the progress of the transition (Figure 5.20).
Figure 5.24 Performing Transition — Transition Module (4-Keyer Shown)
7. After the transition is complete, notice that the video sources you selected on the
Background and Preset buses have swapped, or flip-flopped (Figure 5.25). What was
on the Preset bus is now on the Program bus.
Figure 5.25 Video Sources Selected — After Transition
This completes the procedure for performing an auto transition. You can use the same procedure
to perform a transition on any other MLE or AuxKey.
BKGD
T RANSITION
KEY 1 KEY 2
FRAMES
PST
BKGD
TRANS
PV
KEY
PRIOR
TRANS
LIMIT
DISS
ROLL
CLIP
WIPE DVE SEQ
CUT
AUTO
TRANS
KEY 3 KEY 4
BKGD
T RANSITION
KEY 1 KEY 2
FRAMES
PST
BKGD
TRANS
PV
KEY
PRIOR
TRANS
LIMIT
DISS
ROLL
CLIP
WIPE DVE SEQ
CUT
AUTO
TRANS
KEY 3 KEY 4
SEL
Background Bus
Keyer Bus
Preset Bus