Vision Operator’s Manual (v12.0 MD) WARP Effects • Ops 17–29
•Use the Direction knob on the S&T WARP Menu, or the positioner, to adjust the
direction of the wind, within the direction that the effect is progressing in.
5. Adjust the edge peaks of the effect as follows:
• Press Edge Peaks on the S&T WARP Menu.
Sand (Edge Peaks) — S&T WARP Menu
•Use the Frequency knob on the S&T WARP Menu, or the positioner, to adjust
the number of peaks along the trailing edge of the effect.
•Use the Amplitude knob on the S&T WARP Menu, or the positioner, to adjust the
size of the peaks along the trailing edge of the effect.
6. Adjust the edge curves of the effect as follows:
• Press Edge Curves on the S&T WARP Menu.
Sand (Edge Curves) — S&T WARP Menu
•Use the Slope knob on the S&T WARP Menu, or the positioner, to adjust the
angle of the peaks along the trailing edge of the effect.
•Use the Phase knob on the S&T WARP Menu, or the positioner, to adjust the
position of the peaks along the trailing edge of the effect.
This completes the procedure for setting up a Sand WARP.
To Next Page
Loading...
