Vision Operator’s Manual (v12.0 MD) Keying • Ops 7–25
• A Preset Pattern Key supports the following pattern parameters. Refer to the section
“Pattern Parameters” on page Ops 6-5 for more information on setting pattern
parameters.
› Aspect
› Border/Soft (does not apply to all patterns)
› Rotation
› Horizontal and Vertical Multiplication
9. Select additional key modifiers as desired, using the buttons on the Keyers Module. The
available modifiers are as follows:
• KEY INV
• MASK
• FLY KEY (Squeeze & Tease MD only)
• BORD ON (XFX Dual Border Generator only)
Note — The Fly Key function (Squeeze & Tease MD) can be regarded as a key modifier, but it
is important to note that it creates a different type of key when used with a preset pattern. When
FLY KEY is enabled, the switcher creates a bordered box around the selected pattern, which
can be manipulated in 2D space. Special Squeeze & Tease MD key modifiers are enabled, such
as size, position, mirror, and crop, but the Preset Pattern key modifiers, such as clip, gain,
aspect, border, and softness, are disabled.
This completes the procedure for setting up a Preset Pattern Key. Once set up, the key can be
taken on-air using the transition button on the Keyers Module, or using the Transition Module.
For More Information...
• on setting up your preview monitors to view your key, refer to the section “Video
Preview” on page Ops 4-14.
• on performing transitions, refer to the section “Performing Transitions” on page Ops
5-12.
• on working with Squeeze & Tease MD keys (Fly Keys), refer to the section “Flying
Keys” on page Ops 12-10.
To Next Page
Loading...
