Vision Operator’s Manual (v12.0 MD) Keying • Ops 7–31
•Use the Size knob on the Border Menu, or twist the positioner, to adjust the size of
the border.
4. Press Glow/Density on the Border Menu.
Glow/Density — Border Menu
•Use the Glow knob on the Border Menu to adjust the softness of the edges of the
border.
•Use the Density knob on the Border Menu to adjust the transparency of the
border.
5. Apply the ghost effect to the border as follows:
• Toggle Ghost on the Border Menu to On to remove the key from the video signal,
but keep the border. Unlike Outline, Ghost does not mask out the portion of the
border that is behind the key.
Operating Tip — You can adjust the matte or wash color of the border by pressing Border
Matte on the Border Menu.
This completes the procedure for bordering a key. If you make changes to the border and then
turn it off for a particular Keyer, the settings are retained for when you turn it back on again.
For More Information...
• on Key Trails, refer to the section “Key Trails” on page Ops 7-32.
• on adjusting the matte or wash color of the border, refer to the section “Washes and
Mattes” on page Ops 6-11.
To Next Page
Loading...
