Ops 7–38 • Keying Vision Operator’s Manual (v12.0 MD)
Operating Tip — If the Clip and Gain values are locked, you can unlock them by toggling
the KEY MEM button on the Keyers Modules to OFF.
4. Adjust the Clip and Gain of the key as follows:
• Press Clip/Gain on the MultiDSK Menu.
•Use the Clip knob on the MultiDSK Menu to adjust the clip level.
•Use the Gain knob on the MultiDSK Menu to adjust the gain, or softness.
Operating Tip — You can return the Clip and Gain values to the default setting by pressing
the Make Key Linear button on the Self Key Setup Menu.
5. Adjust the Transparency of the key as follows:
• Toggle Transparency on the MultiDSK Menu to On.
•Use the Transparency knob on the MultiDSK Menu to adjust the transparency of
the key from opaque (0%) to fully transparent (100%).
6. Adjust the Transition Rates for the MultiDSK Keyers as follows:
• Press Trans Rate on the MultiDSK Menu.
Transition Rate — MultiDSK Menu (4-Keyer Shown)
Note — On the 2-Keyer model, the Downstream Keyers are DSK 3 and DSK 4.
•Use the DSK 5 knob on the MultiDSK Menu to adjust the transition rate of
Keyer 5 in frames.
•Use the DSK 6 knob on the MultiDSK Menu to adjust the transition rate of
Keyer 6 in frames.
7. Lock the selected MultiDSK as follows:
• Toggle Locked on the MultiDSK Menu to Yes to lock the selected MultiDSK
Keyer. When locked, you cannot change the video source or key type of the key.
8. Select additional key modifiers as desired, using the buttons on the Keyers Module. The
available modifiers are as follows:
• KEY INV
This completes the procedure for setting up a MultiDSK Key. Once set up, the key can be taken
on-air using the transition button on the Keyers Module, or using the Transition Module.
To Next Page
Loading...
