Ops 15–6 • Squeeze & Tease Sequences and Wipes Vision Operator’s Manual (v12.0 MD)
› Dissolve — This wipe modifier dissolves the channel as the sequence
progresses, based on the Dissolve At value. The Dissolve At value is the
percentage of the way through the sequence that the dissolve will start.
› None — This wipe modifier performs a cut at the end of the sequence. This is
designed for sequences that end with the channel off-screen or not visible on
the screen.
15. Press Insert Keyframe to insert the last keyframe.
This completes the procedure for creating a four keyframe sequence. Now that you have created a
sequence, you must save it to a sequence register.
For More Information...
• on storing and recalling sequences, refer to the section “Saving and Loading Sequences
and Wipes” on page Ops 15-10.
• on the supplied wipes, refer to the section “Squeeze & Tease MD Wipes and
Sequences” on page Ops 18-2.
• on supplied sequences, refer to the section “Squeeze & Tease MD Wipes and
Sequences” on page Ops 18-2.
Sequences are created to move and modify a channel in a series of predetermined effects. You
create sequences using the various Squeeze & Tease menus.
Note — If you want to run a sequence with multiple channels, ensure the sequence was
created with multiple channels. Running a sequence created with a single channel on a Keyer
with multiple channels active will only move the first channel.
To Next Page
Loading...
