Vision Operator’s Manual (v12.0 MD) Lighting & Preprocessor Effects • Ops 16–3
•Use the Intensity knob on the S&T MD Lighting Menu, or the positioner, to
select the intensity of the directional light.
7. Select a preset position or lighting level as follows:
• Press Presets on the S&T MD Lighting Menu.
Preset — S&T MD Lighting Menu
•Use the Presets knob on the S&T MD Lighting Menu to select the lighting or
position preset you want to use. You can choose between the following:
› Other — Select this option to manually position the light.
› Center — Select this option to have the directional light placed at the center
and slightly in front of the channel at the current intensity.
› Top Left — Select this option to have the directional light placed at the top
left corner and slightly in front of the channel at the current intensity.
› Top Right — Select this option to have the directional light placed at the top
right corner and slightly in front of the channel at the current intensity.
› Close — Select this option to have the directional light placed at the center of
the channel at the current intensity.
› Dim — Select this option to apply a low intensity directional and ambient
light.
› Ambient Only — Select this option to apply only the ambient lighting,
ignoring the directional lighting effects. This allows you to turn the lighting on
for a sequence so that lighting effect can be added smoothly.
8. Adjust the position of the directional light source as follows:
• Press Position on the S&T MD Lighting Menu.
Position — S&T MD Lighting Menu
To Next Page
Loading...
