Vision Operator’s Manual (v12.0 MD) WARP Effects • Ops 17–17
5. Apply effects to the magnified area as follows:
• Press Effects on the S&T WARP Menu.
Magnify (Effects) — S&T WARP Menu
•Use the Background knob on the S&T WARP Menu to select whether the
background is visible or not.
› Hide — Select this option to have the background region that is not being
magnified not shown.
› Show — Select this option to have the background region that is not being
magnified shown.
•Use the Edge Effect knob on the S&T WARP Menu to turn borders for the lens
effect on or off.
› Off — Select this option to not have borders applied to the edges of the
magnified area.
› On — Select this option to have borders applied to the edges of the magnified
area.
•Use the Angle (deg.) knob on the S&T WARP Menu, or the positioner, to adjust
the angle of the magnified area.
This completes the procedure for setting up a Magnify WARP.
To Next Page
Loading...
