AP Maintenance
31.3 Converting an AP to a Remote AP and Campus AP
SCALANCE W1750D UI
476 Configuration Manual, 02/2018, C79000-G8976-C451-02
5. Click
to complete the conversion. The AP reboots and begins operating in
the Remote AP mode.
6. After conversion, the AP is managed by the mobility controller.
Note
For APs to function as Remote APs, configure the AP in the Remote AP whitelist and
enable the FTP service on the
controller.
Note
If the VPN setup fails and an error message is displayed, click OK
, copy the error logs,
and share them with your local administrator.
Converting an AP to a Campus AP
To convert an AP to a Campus AP:
1. Click
in the SCALANCE W main window.
2. Click the
tab. The
tab contents are displayed.
Figure 31-2 Converting an AP to Campus AP
3. Select
Campus APs managed by a Mobility Controller
from the drop-down list.
4. Enter the host name, Fully Qualified Domain Name (FQDN), or the IP address of the
controller in the
Hostname or IP Address of Mobility Controller
text box. Contact your
local administrator to obtain these details.
5.
Enter the host name, Fully Qualified Domain Name (FQDN), or the IP address of the
controller in the
Hostname or IP Address of Mobility Controller
text box. Contact your
local administrator to obtain these detail
Converting an AP to Stand-Alone Mode
This feature allows you to deploy an AP as an autonomous AP, which is a separate entity
from the existing VC cluster in the Layer 2 domain.
When an AP is converted to function in stand-alone mode, it cannot join a cluster of APs
even if the AP is in the same VLAN. If the AP is in the cluster mode, it can form a cluster with
other VC APs in the same VLAN.
Das verknüpfte Bild kann nicht angezeigt werden. Möglicherweise wurde die Datei verschoben, umbenannt oder gelöscht. Stellen Sie sicher, dass die Verknüpfung auf die korrekte Datei und den korrekten Speicherort zeigt.
To Next Page
Loading...
Need help?
General
