Engineering via SICAM TOOLBOX II
SICAM RTUs, User Manual SICAM CMIC 117
DC8-001-2.09, Edition 08.2016
For the loading of the parameters there are different variants available:
• Load intelligent
─ only the changed parameters are loaded into the target device
─ can be applied locally or remotely
─ after the loading of the parameters an automatic startup of the target device is per-
formed (for each selected automation unit a corresponding notification appears subse-
quently)
• Load unconditional
─ all parameters are loaded into the target device
─ can be applied locally or remotely
─ after the loading of the parameters an automatic startup of the target device is per-
formed (for each selected automation unit a corresponding notification appears subse-
quently)
• Initialize
─ all parameters are deleted in the target device, and all parameters newly transferred
─ can be applied only with the locally connected automation unit
─ is used for the first loading of an automation unit or of a basic system element
─ if a changed parameter requires a startup of the basic system element, a notice ap-
pears after the loading, whether the startup is to be performed immediately or at a later
time – for instance if further changed parameters are to be activated jointly
You find the details thereto in the SICAM TOOLBOX II Online Help, chapter “Service Pro-
grams”, section “Parameter Loader”.
Caution
During a loading operation, the switching off of the system is to be absolutely avoided, since the data on
the flash card could be destroyed as a result.
4.1.9.2 Parameter Comparison
With the tool “Parameter Loader” you can check whether the parameter status in the target
device is current. You can select an automation unit and start the comparison via the menu
Parameter | Comparison Aus <-> Toolbox ).
For each selected automation unit appears the indication whether the parameters are current
or not current.
To Next Page
Loading...
Need help?
General
