Engineering via SICAM WEB
170 SICAM RTUs, User Manual SICAM CMIC
DC8-001-2.09, Edition 08.2016
5.1.9.2 Assign Signals to the Master Control Element (Master Module)
If you have already defined signals, these can be assigned to the master control element for
the further processing.
This is how to assign signals to the master control element:
• Click on the button on the upper right side to close the workspace for the signals
generation
• Select the directory SICAM CMIC | Master module
• Mark on the right side the signals you want to assign
• Click on the button (Assign)
The assigned signals are now listed in a table under the tab Assignment.
Note
You can enlarge the work area by clicking on the bars right and/or left beside the work area.
To Next Page
Loading...
Need help?
General
