Siemens SICAM CMIC - Point-To-Point Connection Via Serial Interface

Preparing the Engineering
82 SICAM RTUs, User Manual SICAM CMIC
DC8-001-2.09, Edition 08.2016
3.7.2.2.1 Point-to-Point Connection via Serial Interface
The following steps are necessary:
• Configure IP address for engineering PC
• Connection setup via SICAM WEB
Configure IP Address for Engineering PC
For the parameter setting the IP addresses predefined in SICAM CMIC are used. Thereby the
web server of the target device assignes automatically the IP address 172.16.0.2 to the
engineering PC, if this is configured for the automatic acceptance of an IP address.
For the communication via the serial interface, a dial-up connection must be set up on the en-
gineering PC. You find the instruction thereto in Appendix D, Set Up Dial-Up Connection via
PPP.
Connection via SICAM WEB
Start the web browser and enter the IP address of your target device (172.16.0.1) in the
address bar.
You find the further information in chapter 5, Engineering via SICAM WEB.