EasyManuals Logo

Siemens SICAM CMIC User Manual

Siemens SICAM CMIC
414 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #127 background imageLoading...
Page #127 background image
Engineering via SICAM TOOLBOX II
SICAM RTUs, User Manual SICAM CMIC 127
DC8-001-2.09, Edition 08.2016
4.2.2.2 Open-/Closed-Loop Control Function
In the project hierarchy of the tool “CAEx plus”, by selecting one of each level, by means of
pop-up menu the function Print can be executed. The print operation is started on the de-
fault printer of the PC.
You find the details thereto in the CAEx plus Online Help, chapter “Basics”, section “Default
Operating Elements”, section “Commands of the Pop-Up Menus”, section “Print in Project
Management”.
Additional information can be found in the CAEx plus Online Help, chapter “Basics”, section
“Default Properties” as well as chapter “Lists and References”, section “Designing Printouts
with DXF.
Further extensive possibilities for the documentation are provided by the optional function
Document Management (additional product for “CAEx plus”).
You find the details thereto in the CAEx plus Online Help, chapter “Additional Products”, sec-
tion “Documents Management (optional)”.
4.2.3 Commissioning and Test
4.2.3.1 Loading Program Code
To load the compiled program code into the target device, the engineering PC must be con-
nected with the target device (see 3.7, Connecting Engineering PC with the Target Device).
The loading of the program code into the target device takes place jointly with the parameters
set in the “OPM II”. Thereto the tool “Parameter Loader” must be used (see also section
4.1.9.1, Loading Engineering Data).
Caution
During a loading operation, the switching off of the master control element is to be absolutely avoided,
since the data on the SD card could be destroyed as a result.
You find the technical description thereto in the manual SICAM RTUs Common Functions
System and Basic System Elements, chapter “Automation”, section “Open-/Closed-Loop Con-
trol Function”, “Loading of Application Program (Reload)”.
You find the instruction for the operation in the SICAM TOOLBOX II Online Help, chapter
“Service Programs”, section “Parameter Loader”.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SICAM CMIC and is the answer not in the manual?

Siemens SICAM CMIC Specifications

General IconGeneral
BrandSiemens
ModelSICAM CMIC
CategoryRemote Control
LanguageEnglish

Related product manuals