SICAM RTUs, User Manual SICAM CMIC 3
DC8-001-2.09, Edition 08.2016
Preface
Purpose of this manual
This manual describes how to install and parameterize a SICAM CMIC system, which errors
may occur and which are the existing diagnostic options.
Particularly it contains the following information:
• Safety instructions
• Installation instructions
• Hardware descriptions (modules)
• Engineering options
• Parameterization of telecontrol applications
• Programming of open-/closed-loop control functions
• Saving and loading of application data
• Test functions
• Loading of firmware
• Diagnosis
Target Group
The document you are reading right now is addressed to users, who are in charge of the fol-
lowing engineering tasks:
• Conceptual activities, as for example design and configuration
• Mechanical installation
• Creation of the assembly technical documentation
• Engineering and testing with the designated engineering tools
• Technical system maintenance and service, module handling
Within this manual there are hints how to obtain information or files by means of the website
http://www.siemens.com/sicam. If you have no access please consult your project manager at
Siemens.
Recommendations for Third-party Products
Siemens does neither receive liability nor warranty for recommendations which are given or
implied by this manual. For the correct and intended use of the respective product the associ-
ated technical descriptions must be paid attention to in any case.
Links to Third-Party Websites
Siemens is not responsible for the contents of third-party websites mentioned in this docu-
ment, as well as the correctness of the publications and links. For all product information the
respective manufacturer is responsible.
To Next Page
Loading...
Need help?
General
