SICAM RTUs, User Manual SICAM CMIC 63
DC8-001-2.09, Edition 08.2016
3 Preparing the Engineering
Contents
3.1 Engineering Tools .......................................................................................... 64
3.2 Software for the Engineering .......................................................................... 65
3.3 Loadable Firmwares ....................................................................................... 69
3.4 Integrated Protocol SNMP .............................................................................. 70
3.5 SD Card ......................................................................................................... 73
3.6 Interfaces for the Communication ................................................................... 74
3.7 Connecting Engineering PC with the Target Device ........................................ 75
3.8 Interaction with the Engineering Tool .............................................................. 88
This chapter describes with which methods the system SICAM CMIC can be parameterized
and programmed, and which prerequisites must be fulfilled thereto.
To Next Page
Loading...
Need help?
General
