Siemens SICAM CMIC User Manual

Table of Contents
SICAM RTUs, User Manual SICAM CMIC 15
DC8-001-2.09, Edition 08.2016
5.1.2.3 Differentiation Secure/Non-Secure Passwords .................................... 139
5.1.2.4 Set IP Addresses ................................................................................ 142
5.1.2.4.1 Access Options for the Engineering PC in Operation ...................... 143
5.1.2.5 Autoconfiguration................................................................................ 144
5.1.3 Common Settings .................................................................................... 147
5.1.3.1 Configuration of the Target Device ...................................................... 147
5.1.3.1.1 Application Program ...................................................................... 147
5.1.3.2 Topology ............................................................................................ 148
5.1.3.3 Failure Behavior upon Fault ................................................................ 148
5.1.4 Parameterize Hardware Configuration ..................................................... 149
5.1.4.1 Overview ............................................................................................ 149
5.1.4.2 Protocol Elements .............................................................................. 151
5.1.4.3 Peripheral Element ............................................................................. 152
5.1.5 Configuring Time Management ................................................................ 154
5.1.5.1 Time Synchronization ......................................................................... 154
5.1.5.1.1 Time Synchronization with Multi-Point Traffic ................................. 155
5.1.5.1.2 Time Synchronization with Dial-upTraffic........................................ 155
5.1.5.1.3 Time Synchronization with Ethernet ............................................... 155
5.1.5.2 Daylight Saving Time Rule .................................................................. 156
5.1.6 Local Time Setting ................................................................................... 157
5.1.7 Configure Communication ....................................................................... 158
5.1.7.1 Common Settings ............................................................................... 158
5.1.7.2 Physical Interface for the Communication ........................................... 159
5.1.7.3 Select Transmission Facility................................................................ 160
5.1.7.4 Settings of the Messages.................................................................... 161
5.1.7.5 Data Management and Priority Control ............................................... 162
5.1.8 Decentral Archiving ................................................................................. 163
5.1.9 Configure Periphery and Internal Signals ................................................. 165
5.1.9.1 Defining Signals ................................................................................. 165
5.1.9.1.1 Duplicate and Delete Rows ............................................................ 168
5.1.9.1.2 Automatic Filling and Automatic Incrementation ............................. 169
5.1.9.2 Assign Signals to the Master Control Element (Master Module) .......... 170
5.1.9.2.1 Configurable Logging and Display of Signal States ........................ 172
5.1.9.2.2 Parameters with Assignment on the Master Control Module ........... 176
5.1.9.3 Assigning Signals to the Peripheral Element (I/O Master Module) ....... 182
5.1.9.3.1 Parameters with Assignment on the Peripheral Element ................ 185
5.1.9.4 Assigning Signals to the I/O Module.................................................... 186
5.1.9.4.1 Automatic Display of Signal States ................................................. 189
5.1.9.4.2 Parameters with Assignment on the DI Module .............................. 189
5.1.9.4.3 Parameters with Assignment on the DO Module ............................ 192
5.1.9.4.4 Parameters with Assignment on the AI Module .............................. 204
5.1.9.4.5 Parameters with Assignment on the AO Module............................. 209
5.1.9.5 Circuitry of Signals .............................................................................. 211
5.1.9.5.1 Binary Information Acquisition ........................................................ 212

Siemens SICAM CMIC Specifications

General

Brand	Siemens
Model	SICAM CMIC
Category	Remote Control
Language	English