Engineering via SICAM WEB
250 SICAM RTUs, User Manual SICAM CMIC
DC8-001-2.09, Edition 08.2016
After successful upload, the content of the IL is displayed in the logic page and an automatic
Syntax Check is performed.
The result of the syntax check is displayed in the bottom toolbar. In case of error you will find
further details in the status log.
• Click on the general button , if you want to read the status log
In case of error, please consider the conventions described in section 5.2.1, Creating an In-
struction List (IL).
This is how to activate an IL in the target device:
The changed data must be saved, otherwise the IL will be rejected when leaving the session.
• Click on the general button , if you want to save the IL
The application programm will be saved on the SD card. After the saving, a restart of the tar-
get device is required.
During startup the newly loaded program code is compiled,checked and written in the program
memory. An already present program code is thereby overwritten.
• If no error is present, the program is processed after startup.
• If an error is present, the program is shut down and an error indication is recorded in the
diagnosis and in the history.
Note
For the transmission via Ethernet, it is recommended to deactivate the settings for HTTP 1.1 of your PC
(Control Panel, Internet Options, tab "Advanced"). Otherwise the possibility exists that SICAM CMIC can
not interprete the transmitted ASCII file.
To Next Page
Loading...
Need help?
General
