Engineering via SICAM WEB
262 SICAM RTUs, User Manual SICAM CMIC
DC8-001-2.09, Edition 08.2016
The following information will appear during a restart:
Depending on the size of the engineering data, the startup procedure can take a few minutes.
A successful restart of the device is shown by the following dialog:
• Click in order to quit the session with the target device
• Click the suitable hyperlink in order to return to the Logon page of the previously started
target device
• If in the target device the parameter Autoconfiguration was set to YES, the IP address
is set to 169.254.0.1; that remains until it is assigned anew by the set DHCP server (see
5.1.2.5, Autoconfiguration)
Caution
A startup concernes also the automation function (if used). You find further information in section 5.2.2,
Commissioning and Test.
Note
With the initial commissioning, the startup may last up to 10 minutes, since at this the files on the SD card
will be unpacked and the system folders on the
SD card are created.
To Next Page
Loading...
Need help?
General
