Preparing the Engineering
SICAM RTUs, User Manual SICAM CMIC 87
DC8-001-2.09, Edition 08.2016
Connection via SICAM WEB
Start the web browser and enter that IP address in the address bar you have previously as-
signed to your target device.
You find the further information in chapter 5, Engineering via SICAM WEB.
Note
According to the parameterization in SICAM CMIC you have to enter a http or https –address in the
browser to establish the connection.
During the first time connetion establishment via https there is a check if the corresponding security certifi-
cate is installed. If it is missing, it must be installed manual.
The security function HTTPS is supported in SICAM CMIC from:
• Hardware CP-8000, product version ***CC
• Firmware CPC80, revision 04
Configure IP Address via Autoconfiguration
In a network, the IP address of the physically connected SICAM CMIC automation units can
be assigned by a DHCP server.
The DHCP service is switched off by default and can be only activated by means of parameter
(see 5.1.2.5, Autoconfiguration).
To Next Page
Loading...
