ST STM32F2 - Page 185

UM1940
HAL DCMI Generic Driver
DocID028236 Rev 2
185/1371
HAL_DCMI_ERROR_DMA
DMA error
DCMI Exported Macros
__HAL_DCMI_RESET_HANDLE_STATE
Description:
Reset DCMI handle state.
Parameters:
__HANDLE__: specifies the DCMI
handle.
Return value:
None
__HAL_DCMI_ENABLE
Description:
Enable the DCMI.
Parameters:
__HANDLE__: DCMI handle
Return value:
None
__HAL_DCMI_DISABLE
Description:
Disable the DCMI.
Parameters:
__HANDLE__: DCMI handle
Return value:
None
__HAL_DCMI_GET_FLAG
Description:
Get the DCMI pending flag.
Parameters:
__HANDLE__: DCMI handle
__FLAG__: Get the specified flag. This
parameter can be one of the following
values (no combination allowed)
DCMI_FLAG_HSYNC: HSYNC pin
state (active line / synchronization
between lines)
DCMI_FLAG_VSYNC: VSYNC pin
state (active frame / synchronization
between frames)
DCMI_FLAG_FNE: FIFO empty flag
DCMI_FLAG_FRAMERI: Frame
capture complete flag mask
DCMI_FLAG_OVRRI: Overrun flag
mask
DCMI_FLAG_ERRRI:
Synchronization error flag mask
DCMI_FLAG_VSYNCRI: VSYNC