SDIO_IT_TXDAVL: Data available in transmit
FIFO interrupt
SDIO_IT_RXDAVL: Data available in receive
FIFO interrupt
SDIO_IT_SDIOIT: SD I/O interrupt received
interrupt
Return value:
The: new state of MMC IT (SET or RESET).
Description:
Clear the MMC's interrupt pending bits.
Parameters:
__HANDLE__: MMC Handle
__INTERRUPT__: specifies the interrupt pending bit
to clear. This parameter can be one or a combination
of the following values:
SDIO_IT_CCRCFAIL: Command response
received (CRC check failed) interrupt
SDIO_IT_DCRCFAIL: Data block sent/received
(CRC check failed) interrupt
SDIO_IT_CTIMEOUT: Command response
timeout interrupt
SDIO_IT_DTIMEOUT: Data timeout interrupt
SDIO_IT_TXUNDERR: Transmit FIFO underrun
error interrupt
SDIO_IT_RXOVERR: Received FIFO overrun
error interrupt
SDIO_IT_CMDREND: Command response
received (CRC check passed) interrupt
SDIO_IT_CMDSENT: Command sent (no
response required) interrupt
SDIO_IT_DATAEND: Data end (data counter,
SDMMC_DCOUNT, is zero) interrupt
SDIO_IT_SDIOIT: SD I/O interrupt received
interrupt
Return value:
None
To Next Page
Loading...
