ST STM32F2 User Manual

HAL MMC Generic Driver
UM1940
368/1371
DocID028236 Rev 2
response required)
SDIO_FLAG_DATAEND: Data end (data
counter, SDIDCOUNT, is zero)
SDIO_FLAG_DBCKEND: Data block
sent/received (CRC check passed)
SDIO_FLAG_SDIOIT: SD I/O interrupt received
Return value:
None
__HAL_MMC_GET_IT
Description:
Check whether the specified MMC interrupt has
occurred or not.
Parameters:
__HANDLE__: MMC Handle
__INTERRUPT__: specifies the SDMMC interrupt
source to check. This parameter can be one of the
following values:
SDIO_IT_CCRCFAIL: Command response
received (CRC check failed) interrupt
SDIO_IT_DCRCFAIL: Data block sent/received
(CRC check failed) interrupt
SDIO_IT_CTIMEOUT: Command response
timeout interrupt
SDIO_IT_DTIMEOUT: Data timeout interrupt
SDIO_IT_TXUNDERR: Transmit FIFO underrun
error interrupt
SDIO_IT_RXOVERR: Received FIFO overrun
error interrupt
SDIO_IT_CMDREND: Command response
received (CRC check passed) interrupt
SDIO_IT_CMDSENT: Command sent (no
response required) interrupt
SDIO_IT_DATAEND: Data end (data counter,
SDIDCOUNT, is zero) interrupt
SDIO_IT_DBCKEND: Data block sent/received
(CRC check passed) interrupt
SDIO_IT_CMDACT: Command transfer in
progress interrupt
SDIO_IT_TXACT: Data transmit in progress
interrupt
SDIO_IT_RXACT: Data receive in progress
interrupt
SDIO_IT_TXFIFOHE: Transmit FIFO Half
Empty interrupt
SDIO_IT_RXFIFOHF: Receive FIFO Half Full
interrupt
SDIO_IT_TXFIFOF: Transmit FIFO full interrupt
SDIO_IT_RXFIFOF: Receive FIFO full interrupt
SDIO_IT_TXFIFOE: Transmit FIFO empty
interrupt
SDIO_IT_RXFIFOE: Receive FIFO empty
interrupt

ST STM32F2 Specifications

General

Brand	ST
Model	STM32F2
Category	Microcontrollers
Language	English