ST STM32F2 - Page 526

HAL SD Generic Driver
UM1940
526/1371
DocID028236 Rev 2
SDIO_IT_DTIMEOUT: Data timeout interrupt
SDIO_IT_TXUNDERR: Transmit FIFO underrun
error interrupt
SDIO_IT_RXOVERR: Received FIFO overrun
error interrupt
SDIO_IT_CMDREND: Command response
received (CRC check passed) interrupt
SDIO_IT_CMDSENT: Command sent (no
response required) interrupt
SDIO_IT_DATAEND: Data end (data counter,
SDIDCOUNT, is zero) interrupt
SDIO_IT_DBCKEND: Data block sent/received
(CRC check passed) interrupt
SDIO_IT_CMDACT: Command transfer in
progress interrupt
SDIO_IT_TXACT: Data transmit in progress
interrupt
SDIO_IT_RXACT: Data receive in progress
interrupt
SDIO_IT_TXFIFOHE: Transmit FIFO Half Empty
interrupt
SDIO_IT_RXFIFOHF: Receive FIFO Half Full
interrupt
SDIO_IT_TXFIFOF: Transmit FIFO full interrupt
SDIO_IT_RXFIFOF: Receive FIFO full interrupt
SDIO_IT_TXFIFOE: Transmit FIFO empty
interrupt
SDIO_IT_RXFIFOE: Receive FIFO empty interrupt
SDIO_IT_TXDAVL: Data available in transmit
FIFO interrupt
SDIO_IT_RXDAVL: Data available in receive FIFO
interrupt
SDIO_IT_SDIOIT: SD I/O interrupt received
interrupt
Return value:
None
__HAL_SD_DISABLE_IT
Description:
Disable the SD device interrupt.
Parameters:
__HANDLE__: SD Handle
__INTERRUPT__: specifies the SDMMC interrupt
sources to be disabled. This parameter can be one or a
combination of the following values:
SDIO_IT_CCRCFAIL: Command response
received (CRC check failed) interrupt
SDIO_IT_DCRCFAIL: Data block sent/received
(CRC check failed) interrupt
SDIO_IT_CTIMEOUT: Command response
timeout interrupt
SDIO_IT_DTIMEOUT: Data timeout interrupt
SDIO_IT_TXUNDERR: Transmit FIFO underrun