Tektronix TBS2000 Series User Manual

Syntax
CURSor:VBArs:HPOS<x>?
Related Commands
CURSor:HBArs:UNIts on page 80
Returns
<x> indicates the cursor. Valid values are 1 and 2.
Examples
CURSOR:VBARS:HPOS1? might return CURSOR:VBARS:HPOS2 100E-3,
indicating the value of one vertical bar tick.
CURSor:VBArs:POSITION<x>
Positions a vertical bar cursor. The unit is specified by the CURSor:VBArs:UNIts
command, and can be in units of seconds or frequency (Hertz). If the cursor
source is an FFT math waveform, CURSor:VBArs:POSITION is always in
Hertz, regardless of the value set by CURSor:VBArs:UNIts.
NOTE. If Trigger View is active, the query form returns 9.9E37 and generates
event 221 (Settings conflict).
Group
Cursor
Syntax
CURSor:VBArs:POSITION<x>
CURSor:VBArs:POSITION<x>?
Arguments
<x> specifies which cursor to position. Correct values are 1 and 2.
<NR3> specifies the cursor position in the units specified by the
CURSor:VBArs:UNIts command. The position is relative to the trigger except
when the cursor source is a math FFT waveform. The cursor position is limited to
the graticule whenever an attempt is made to move it outside the graticule.
C commands
TBS2000 Series Programmer 85

Tektronix TBS2000 Series Specifications

General

Brand	Tektronix
Model	TBS2000 Series
Category	Test Equipment
Language	English