DIAg:RESUlt:FLAg?
Returns the Pass/Fail status from the last diagnostic test sequence execution
(those run automatically at power on, or those requested through the Service
Menu). Use the DIAg:RESUlt:LOG? query to determine which test(s) has failed.
Query only.
Group
Calibration and Diagnostic
Syntax
DIAg:RESUlt:FLAg?
Returns
PASS means that the instrument passes all selected diagnostic tests.
FAIL means that the instrument has failed at least one of the diagnostic tests.
Examples
DIAg:RESUlt:FLAG
Returns either PASS or FAIL.
DIAg:RESUlt:LOG?
Returns the internal results log from the last diagnostic test sequence execution
(those run automatically at power on, or those requested through the Service
Menu). The list contains all modules and module interfaces that were tested with
the pass or fail status of each. Query only.
Group
Calibration and Diagnostic
Syntax
DIAg:RESUlt:LOG?
D commands
TBS2000 Series Programmer 99
To Next Page
Loading...
Need help?
General
