Tektronix TBS2000 Series User Manual

MEASUrement:IMMed:SOUrce1
Sets or queries the source for all single source immediate measurements and
specifies the source to measure from when taking an immediate delay or phase
measurement. Digital channels (D<x>) are available as a measurement source for
time, edge and pulse measurements such as Period, Frequency, Pos Width, Neg
Width, Pos Duty Cycle, Neg Duty Cycle, Pos/Neg Edges and Pos/Neg Pulses,
Delay, and Phase.
NOTE. If you do not specify a numerical suffix, the source is assumed to be
SOURCE 1.
Group
Measurement
Syntax
MEASUrement:IMMed:SOUrce1 {CH<x> | MATH}
MEASUrement:IMMed:SOUrce1?
Related commands
MEASUrement:IMMed:SOUrce2 on page 176
Arguments
CH<x> specifies the measurement source channel as one of the input channels.
The value of <x> can vary from 1 through 4 depending on instrument model.
MATH specifies the measurement source channel as the math waveform.
Examples
MEASUREMENT:IMMED:SOURCE1 CH1 specifies channel 1 as the
immediate measurement source.
MEASUREMENT:IMMED:SOURCE1? might
return :MEASUREMENT:IMMED:SOURCE1 CH3 indicating that channel 3 is
the immediate measurement source.
M commands
TBS2000 Series Programmer 175

Tektronix TBS2000 Series Specifications

General

Brand	Tektronix
Model	TBS2000 Series
Category	Test Equipment
Language	English