Tektronix TBS2000 Series

DIAg:LOOP:OPTion:NTIMes
Sets the self-test loop option to run N times.
Group
Calibration and diagnostic
Syntax
DIAg:LOOP:OPTion:NTIMes <NR1>
DIAg:LOOP:OPTion:NTIMes?
Arguments
<NR1> is the number of self-test loops.
Examples
DIAG:LOOP:OPTION:NTIMES 3 sets the self-test loop to run three times.
DIAG:LOOP:OPTION:NTIMES? might
return :DIAG:LOOP:OPTION:NTIMES 5, indicating that the self-test loop is set
to run five times.
DIAg:LOOP:STOP
Stops the self-test at the end of the current loop. No query form.
Group
Calibration and diagnostic
Syntax
DIAg:LOOP:STOP
Examples
DIAG:LOOP:STOP stops the self test at the end of the current loop.
D commands
98 TBS2000 Series Programmer