ALLEv?
Causes the instrument to return all events and their messages, and removes the
returned events from the Event Queue. The messages are separated by commas.
Use the *ESR? query to enable the events to be returned. Refer to the Status and
Events section for a complete description of how to use these registers. This
command is similar to repeatedly sending *EVMsg? queries to the instrument.
Query only.
Group
Status and Error
Syntax
ALLEv?
Related Commands
*CLS on page 75, DESE on page 96, *ESE on page 106, *ESR? on
page 107, EVENT? on page 115, EVMsg? on page 116, EVQty? on page 117,
*SRE on page 219, *STB? on page 220
Returns
The event code and message in the following format:
<Event Code><Comma><QString>[<Comma><Event
Code><Comma><QString>...]
<QString>::= <Message>;[<Command>]
<Command> is the command that caused the error and may be returned when a
command error is detected by the instrument. As much of the command is
returned as possible without exceeding the 60 character limit of the <Message>
and <Command> strings combined. The command string is right-justified.
Examples
ALLEv? might return the following string: ALLEV 2225,"MEASUREMENT
ERROR, NO WAVEFORM TO MEASURE; ",420,"QUERY
UNTERMINATED; "
A commands
48 TBS2000 Series Programmer
To Next Page
Loading...
Need help?
General
