Arguments
<NR3> is offset, expressed in YUNits.
Examples
WFMINPRE:YZERO 1.5E+0 specifies that the zero reference point for the
incoming waveform is 1.5 V below the center of the data range (given that
WFMInpre:YUNit is set to V).
WFMINPRE:YZERO? might return :WFMINPRE:YZEro 7.5000E-6 indicating
that the zero reference for the incoming waveform is 7.5 μV below the center of
the data range (given that WFMInpre:YUNit is set to V).
WFMOutpre?
Returns waveform transmission and formatting settings for the waveform
specified by the DATa:SOUrce command. Query only.
If the waveform specified by the DATa:SOUrce command is not displayed, the
instrument returns only the waveform transmission parameters (BYT_Nr,
BIT_Nr, ENCdg, BN_Fmt, BYT_Or).
Group
Waveform
Syntax
WFMOutpre?
Examples
WFMOUTPRE? might return the waveform formatting data as:
:WFMOUTPRE:BYT_NR 2;BIT_NR 16;ENCDG ASCII;BN_FMT
RI;BYT_ORMSB;WFID "Ch1, DC coupling, 100.0mV/div, 4.000us/div,
10000 points, Sample mode";NR_PT 10000;PT_FMT Y;XUNIT "s";XINCR
4.0000E-9;XZERO - 20.0000E-6;PT_OFF 0;YUNIT "V";YMULT
15.6250E-6;YOFF :"6.4000E+3;YZERO 0.0000.
W commands
TBS2000 Series Programmer 257
To Next Page
Loading...
