Command Description
CALibrate:FACtory:STEPSTIMulus? on
page 55
Return the current factory step’s input stimulus.
DIAg:LOOP:OPTion on page 97 Sets the self-test loop option
DIAg:LOOP:OPTion:NTIMes on page 98 Sets the self-test loop option to run N times
DIAg:LOOP:STOP on page 98 Stops the self-test at the end of the current loop
DIAg:RESUlt:FLAg? on page 99 Returns the Pass/Fail status from the last
diagnostic test sequence execution (those run
automatically at power on, or those requested
through the Service Menu).
DIAg:RESUlt:LOG? on page 99 Returns the internal results log from the last
diagnostic test sequence execution (those run
automatically at power on, or those requested
through the Service Menu).
DIAg:SELect on page 100 Sets the type of diagnostics grouping.
DIAg:SELect:<function> on page 101 Runs self-tests on the specified system
subsystem.
DIAg:STATE on page 101 Starts or stops the instrument self-test.
DIAg:FAN on page 97 Read out the currently set PWM fan value
DIAg:TEMPVAL on page 102 Read out the currently FPGA chip and ambient
temperature
Cursor command group
Cursor commands provide control over the instrument cursor display and
readout.
Use the commands in the cursor command subsystem to control the cursor
display and readout. You can use these commands to control the setups for cursor
1 and cursor 2, such as cursor position. You can also use the commands to select
one of the following cursor functions:
Off. Turns off the display of all cursors.
Waveform Cursors. Consists of two cursors. Waveform cursors enable you to
conveniently measure waveform amplitude and time.
Screen Cursors. Consists of two pairs of independent horizontal and vertical
cursors.
You can use these cursors to indicate an arbitrary position within the waveform
display area.
Command groups
TBS2000 Series Programmer 15
To Next Page
Loading...
Need help?
General
