Tektronix TBS2000 Series User Manual

ACQuire:NUMAVg
Sets or queries the number of waveform acquisitions that make up an averaged
waveform. Use the ACQuire:MODe command to enable Average mode. Sending
this command is equivalent to turning a multipurpose knob to enter the number of
waveform acquisitions to average.
Group
Acquisition
Syntax
ACQuire:NUMAVg <NR1>
ACQuire:NUMAVg?
Arguments
<NR1> is the number of waveform acquisitions to average. The range of values
is from 2 to 512 in powers of two.
Examples
ACQuire:NUMAVg 16 specifies that 16 waveform averages are performed
before exponential averaging starts.
ACQuire:NUMAVg? might return ACQUIRE:NUMAVG 64 indicating that
there are 64 acquisitions specified for averaging.
ACQuire:STATE
Starts or stops acquisitions.
When State is set to ON or RUN, a new acquisition is started. If the last
acquisition was a single acquisition sequence, a new single sequence acquisition
is started. If the last acquisition was continuous, a new continuous acquisition is
started.
If RUN is issued in the middle of completing a single sequence acquisition (for
example, averaging or enveloping), the acquisition sequence is restarted, and any
accumulated data is discarded. Also, the instrument resets the number of
acquisitions. If the RUN argument is issued while in continuous mode,
acquisition continues.
A commands
TBS2000 Series Programmer 41

Tektronix TBS2000 Series Specifications

General

Brand	Tektronix
Model	TBS2000 Series
Category	Test Equipment
Language	English